Feel the Performance Simply the best production
method.
GECHTER Press force monitoring for linear acting pneumatic
presses.
Customized systems for the operator, the motion sequence and the precise
processing of highly sensitive component parts
|
Product overview - GECHTER linear acting pneumatic
press LP-MS with press force monitoring
Linear acting pneumatic press with press force monitoring (force-only
or force-displacement).
The LP-MS linear acting pneumatic presses are in accordance with the
standard LP machine series, together with the well-proven GECHTER
two-hand safety controls ES06M, ZS06M and SEM5M.
|
Product overview - GECHTER LP-MC Press Motion
Control Control for linear acting pneumatic press with ZS06 and SEM
control.
Use the MS00 measuring results to control the continuous work
movement of the operating personnel with the utmost efficiency.
Preconditions:
- If the measuring results are correct, the work movement must not
be disturbed, and the lever must be
- operated quickly in the manufacturing
process.
- If the measuring results are incorrect, the work movement must be
interrupted and the operator instructed - to
recognize bad parts and remove them from the manufacturing process.
A practical example:
On the basis of the measured values, a press inserting process is
classified as NOT OK by the MS00 measuring system.
The GECHTER MS00 system offers the following instructions for the
operator:
A An acoustic signal is audible. The work movement control
does not block the press from further operation
A until after the return stroke. The
signal has to be acknowledged. The block is released, and the production
A process can be resumed.
B If the components are highly sensitive, an acknowledgment
function can optionally be activated with a key
B switch. The key switch is operated by
a superior member of staff to enable the further work process. At
B the same time, the controlled
treatment of the “bad part “ Note: is also ensured.
The following package of components is added to the basic machine to
generate a press of type LP-ES06M-MS, LP-ZS06M-MS, or LP-SEM5M-MS:
1. A digital display unit MS00 with adjustable displacement and force
thresholds, with a table housing for the
1. ES and SEM controls and a
cabinet-integrated housing for the ZS controls.
2. A force sensor (measuring range according to press force), integrated
into the press ram
3. A USB cable
4. PC software (starter version) without graphic display (supplied on
USB flash drive)
Note:
For the types LP MS + MC, a center offset eccentricity of the holding
fixture bore forward is existing. The daylight is lower compared with
the basic machines. See relevant table.
|
Accessories - optional available:
5. A displacement sensor, mounted to the press ram with inverted V guide
6. PC software, extended version with graphic display and license
7. External calibration in a DKD-certified measuring laboratory (no
picture available)
8. For further accessories see standard LP machine series
|
