Feel the Performance Simply the best production
method.
GECHTER Press force monitoring for pneumatic aided manual
toggle presses HKPL MS+MC
Customized systems for the operator, the motion sequence and
the precise processing of highly sensitive component parts
|
Product overview - GECHTER pneumatic aided manual
toggle press with press force monitoring
HKPL-MS, pneumatic aided manual toggle press with press force
monitoring (force-only or force displacement). The presses are in
accordance with the standard pneumatic aided manual toggle presses. The
following package of components is added to the basic machine to
generate a press of type HKPL-MS:
1. a digital display unit MS00A with adjustable displacement and
force thresholds, and an attachment housing 1.
with support foot
2. a force sensor (measuring range according to press force), integrated
into the press ram
3. a PFE fine tuning device
4. a USB cable
5. PC software (starter version) without graphic display (supplied on
USB flash drive)
6. a displacement sensor for additional displacement measuring
(optional)
|
Product overview - GECHTER Press Motion Control
Control for pneumatic aided manual toggle presses HKPL-MC
Use the MS00 measuring results to control the continuous work
movement of the operating personnel with the utmost efficiency.
Preconditions:
- If the measuring results are correct, the work movement must not
be disturbed, and the lever must be
- operated quickly in the manufacturing
process.
- If the measuring results are incorrect, the work movement must be
interrupted and the operator instructed - to
recognize bad parts and remove them from the manufacturing process.
A practical example:
Directly after the beginning of the compression operation by using the
hand lever, a mechanical blockade keeps the press from opening again.
On the basis of the measured values, a press inserting process is
classified as NOT OK by the MS00 measuring system.
The GECHTER MS00 system offers the following instructions for the
operator:
A An acoustic signal is audible. After acknowledgment by the operator
the non-return stroke
A mechanism gets approved and the production process
can be resumed.
B An acoustic signal is audible. The non-return-stroke mechanism
gets approved,
B the following assembly gets avoid by a blockade of the
pressure stroke.
B After acknowledgment by the operator,
the production process can be resumed.
C If the components are highly sensitive, an acknowledgment
function can optionally be activated with a key
C switch. The key switch is operated by
a superior member of staff to enable the further work process. At
C the same time, the controlled
treatment of the “bad part “ is also ensured.
HKPL-MC, Press Motion Control Control for pneumatic aided manual
toggle presses HKPL-MC. To turn a press into an HKPL-MC press, a Press
Motion Control (mechanical module) and control electronics are
integrated into the display unit and added to the HMS components.
6. Displacement sensor for additional displacement measuring (no picture
available)
7. Press Motion mechanical module (no picture available)
Note:
For the types LP MS + MC, a center offset eccentricity of the holding
fixture bore forward is existing. The daylight is lower compared with
the basic machines. See relevant table.
|
Accessories - For both HKPL MS + MC, the following
components and services are available as options:
8. PC software, extended version with graphic display and license (no
picture available)
9. Additional housing for MS00A, with red lamp and key switch for
acknowledgment
10. External calibration in a DKD-certifi ed measuring laboratory (no
picture available)
11. For further accessories see standard HKPL presses
|
